Description
Nuttyfi 2.0 is a development board, based on open-source firmware and development kit, which runs on the ESP8266 with the Espressif Non-OS SDK, an hardware based on the ESP-12 series module. This devices features an on chip wifi Transceiver with 4MB of flash memory, 80MHz of system Clock, around 50k of usable RAM.
Device Summary
- Microcontroller: Tensilica 32-bit RISC CPU Xtensa LX106
- Operating Voltage: 3.3V
- Input Voltage: 7-12V
- Digital I/O Pins (DIO): 9
- Analog Input Pins (ADC): 1
- UARTs: 1
- SPIs: 1
- I2Cs: 1
- Flash Memory: 4 MB
- SRAM: 64 KB
- Clock Speed: 80 Mhz
- Wi-Fi: IEEE 802.11 b/g/n:
- Integrated TR switch, balun, LNA, power amplifier and matching network
- WEP or WPA/WPA2 authentication, or open networks
Power:
Power to the Nuttyfi v2.0 is supplied via three ways:
USB Power: Power to the Nuttyfi v2.0 is supplied via the on-board USB Micro B connector. It proves to an ideal choice for loading programs unless the project you aim to design requires separate interface i.e. disconnected from the computer.
Provide 3.3V: If you have your own power supply that provides 3.3v, you can provide the power to 3.3v pin directly.
Power to Vin Pin: This pin is comes with voltage regulator that ability to support 7V to 12V, 500mA o 700mA.
Nuttyfi V2.0 Features:
- Open-source
- Arduino-like hardware
- Status LED
- Micro USB port
- Reset/Flash buttons
- Interactive and Programmable
- Low cost
- ESP8266 with inbuilt wifi
- USB to UART converter
- IO pins
Reviews
There are no reviews yet.