NuttyFi Fusion X – Dual-Processor IoT Development Board (ESP32 + STM32)

₹ 2,500.00

NuttyFi Fusion X combines two processors on one board: an ESP32-WROOM-32 for Wi-Fi and Bluetooth, and an STM32F103C8T6 for fast, real-time control. Each chip has its own programming pins, so you upload code to either one directly with a programmer. Dedicated 3.3V, 5V and GND pins make sensor wiring clean, and USB-C or a battery powers the board.

Description

NuttyFi Fusion X is a dual-processor development board by SME Dehradun. It puts an ESP32-WROOM-32 and an STM32F103C8T6 side by side, so one board handles both the connected side of a project and the real-time control side.

Core idea: let the ESP32 look after Wi-Fi, Bluetooth and the cloud, while the STM32 looks after timing-critical work such as motors, sensors and control loops.

What you get on the board

    • ESP32-WROOM-32 module: dual-core processor with 2.4 GHz Wi-Fi and Bluetooth.
    • STM32F103C8T6 microcontroller: 32-bit ARM Cortex-M3 running at up to 72 MHz, with 64 KB flash and 20 KB RAM.
  • Separate programming pins for each chip: upload code to the ESP32 or the STM32 directly with a programmer, without removing anything.
  • Dedicated 3.3V, 5V and GND pins: plug sensors and modules straight in, with no breadboard power rails.
  • USB-C power input: power the board from any USB-C cable or adapter.
  • Battery input: a BAT connector for portable projects.
  • Reset and boot buttons for both processors.

Please note: the USB-C port is for power only. Code is uploaded through the programming pins using a programmer such as the NuttyFi Universal Programmer.

Why two processors?

  • No compromise between Wi-Fi and timing: wireless work on the ESP32 never interrupts control code on the STM32.
  • More pins: the input and output pins of both chips are brought out to headers.
  • One board, less wiring: no need to link two separate boards with jumper wires.

Perfect for:

IoT products, industrial monitoring, robotics, motor control with remote access, data loggers, and student projects that need both real-time control and a cloud connection.

Power options:

  • USB-C: 5 V from a USB cable or adapter (power only).
  • BAT input: for battery-powered use.

What you need to program it

A programmer connected to the programming pins of the chip you want to upload to. The NuttyFi Universal Programmer works with both the ESP32 and the STM32 on this board.

Additional information

Weight120 g
Dimensions10 × 5 × 1.0 cm